Shot peening is a critical surface treatment process that enhances material properties by inducing compressive residual stress, improving fatigue life, […]
Filter by categories
AccurasprayHub: Leveraging AI and Machine Learning to Define and Optimize Process Windows in Thermal Spray Operations
Consistent coating quality in thermal spray processes is challenging due to inherent complexity, operator-dependent controls, and evolving equipment conditions. While […]
The Role of HVAF Nozzle Design and Process Parameters on In-Flight Particle Oxidation and Microstructure of NiCoCrAlY Coatings
Increasing demand to deposit dense and oxidation-resistant bond coats requires reliable and efficient deposition techniques. High-Velocity Air-Fuel (HVAF), among other […]
Investigation Of The Corrosion Performance Of HVOF-Sprayed WC-Cocr Coatings Applied On Offshore Hydraulic Equipment
This study investigates the corrosion and erosion-corrosion performance of HVOF-sprayed WC-10Co-4Cr coatings for offshore hydraulic applications. By tuning kerosene (18.1–25.3 l·h−1) […]
Repair of Single-Crystal CMSX-4 Using the High Velocity Air Fuel Process
Turbine blades in aircraft engines and land-based gas turbines are exposed to harsh environmental conditions that make them susceptible to […]
Microstructural Analysis And Tribological Characteristics Of Thermally Sprayed Co-Ni-O Ternary Oxide Coatings
Due to their high thermal and chemical stability, ternary oxide coatings have been extensively investigated as potential solutions for high-temperature […]
Investigation on In-Flight Heating Process of Cerium Oxide Powders in Radio Frequency Thermal Plasma Considering Thermal Resistance Effect
In-flight heating process of powder particles in radio frequency (RF) thermal plasma have great importance for plasma spraying and spheroidization. […]
Role Of Powder Morphology On Α-Phase Content In Plasma Sprayed Alumina Coatings
Despite various studies addressing the retention of α phase in thermal sprayed alumina coatings, a noticeable research gap persists regarding […]
Microstructure and Adhesion Strength of Ti Cold Spray Splats: The Influence of Powder Morphology
Cold spraying is an emerging additive manufacturing technology that can be used to repair metals and alloys. The adhesion strength […]
