Increasing demand to deposit dense and oxidation-resistant bond coats requires reliable and efficient deposition techniques. High-Velocity Air-Fuel (HVAF), among other […]
Filter by categories
Investigation Of The Corrosion Performance Of HVOF-Sprayed WC-Cocr Coatings Applied On Offshore Hydraulic Equipment
This study investigates the corrosion and erosion-corrosion performance of HVOF-sprayed WC-10Co-4Cr coatings for offshore hydraulic applications. By tuning kerosene (18.1–25.3 l·h−1) […]
Repair of Single-Crystal CMSX-4 Using the High Velocity Air Fuel Process
Turbine blades in aircraft engines and land-based gas turbines are exposed to harsh environmental conditions that make them susceptible to […]
Microstructural Analysis And Tribological Characteristics Of Thermally Sprayed Co-Ni-O Ternary Oxide Coatings
Due to their high thermal and chemical stability, ternary oxide coatings have been extensively investigated as potential solutions for high-temperature […]
Investigation on In-Flight Heating Process of Cerium Oxide Powders in Radio Frequency Thermal Plasma Considering Thermal Resistance Effect
In-flight heating process of powder particles in radio frequency (RF) thermal plasma have great importance for plasma spraying and spheroidization. […]
Role Of Powder Morphology On Α-Phase Content In Plasma Sprayed Alumina Coatings
Despite various studies addressing the retention of α phase in thermal sprayed alumina coatings, a noticeable research gap persists regarding […]
Microstructure and Adhesion Strength of Ti Cold Spray Splats: The Influence of Powder Morphology
Cold spraying is an emerging additive manufacturing technology that can be used to repair metals and alloys. The adhesion strength […]
Influence of Deposition Parameters on the Formation of Surface Cracks in Segmented Aps-Tbcs
Thermal barrier coating system (TBCs) prepared using the Air plasma spray (APS) method are widely recognized as the most prevalent […]
Understanding the Impact of Binary Plasma Gas Mixtures in Plasma Spraying
In plasma spraying, H2 or N2 is commonly added to the primary Ar plasma which may increase the specific enthalpy, […]
